In the event the fan doesn’t run, there may be an issue with the most important control board. If he does not run, there might be a problem with the relay board. If he runs intermittently when the selector switch buttons are pushed the switch will have to be replaced. If he turns freely, you need to check its windings for continuity. A condenser fan is utilized on frost-free refrigerators with a condenser coil in the base of the cabinet, in the compressor compartment. The next cause may be the condenser fan.
In case the fan doesn’t run, the drive motor could be defective. If he does not run, the dual shaft fan motor may be defective. He is typically installed close to the compressor and you can locate it in the bottom of the fridge at the back. You would like to put in a new fan or the old fan in exactly the same way.
The Upside to Condenser Fan Motor Wiring
Turn the fan blade to find out whether it moves freely. The fan blades must turn correctly, and needs to be placed to pull air from the unit, if they are set in the incorrect direction the unit will not operate correctly. If it is half way down the coil, when it is running air will only be drawn over the part of the coil below the fan blade. At this time you can eliminate the fan blade from the motor.
The capacitors aren’t overly costly and are simple to replace. Also, it may be defective if the compressor hums but does not start. It’s not needed when employing a dual capacitor. If you opt to replace the dual capacitor completely, you are going to have to obtain the rating marked on the outside the old capacitor. You are altering the run capacitor out so that’s good. Find the Stat Run Capacitor, if it’s a Dual Run capacitor there’ll be only one.
The fan motor isn’t repairable, it’s going to need to be replaced if it’s defective. A condenser fan motor is liable for pulling air from a unit pulling it out past the condenser, much enjoy a fan and radiator in a vehicle. In the event you had the ability to change out your condenser fan motor with the aid of this article please leave a comment and encourage other people to do it themselves too and save a great deal of money.
Motors will often have several speeds. You will find this motor has some additional wires. This motor is installed within the freezer. In this instance the motors are approximately the identical height. In other words, no you didn’t purchase the incorrect condenser fan motor.
As always, consult with the wiring diagram on the specific motor you’re using. You should finally have the new motor connected to the top and the 3 wires hanging from the plastic tube. The next thing you ought to make certain of, is that your new motor is rotating in the proper direction and your fan blade is facing the proper direction. Evaporator fan motor is another frequent reason for the loud racket.